SAAB WIS ONLINE

Rear bumper, 4D

Rear bumper, 4D

To remove



1. Undo the screws in the wheel housing, 2 on each side.

2. Open the boot lid.

3. Fold away the luggage compartment carpet and remove the seals. The old seals must be discarded and replaced by new ones.


4. Remove the nuts holding the bumper. The lower bolts have nuts if the car is equipped with a towbar.

5. Together with an assistant, pull out the bumper from the edges of the wheel housings and lift the bumper out backwards.

Note

For cars equipped with Saab Parking Assistance (SPA):

Unplug the connectors in the bumper.


Important

Be careful to avoid damaging the paintwork.



To fit

Note

For cars equipped with Saab Parking Assistance (SPA):

Plug in the connector.




1. Place the bumper in position and press it over the edge of the wheel housing. Make sure it is in the correct position along the guides in the rear wing.

2. Screw on the nuts by hand.

3. Position the bumper correctly and tighten the screws in the edge of the wheel housing.


4. Tighten the retaining nuts.

5. Fit the new seals and fold down the luggage compartment carpet.

6. Close the boot lid and check the fit.