SAAB WIS ONLINE

Rear bumper, 5D

Rear bumper, 5D

To remove



1. Undo the screws in the wheel housing, 2 on each side.

2. Open the tailgate.

3. Remove the covers from the storage compartments on right and left sides and remove the storage compartments.


4. Remove the insulation pads. The old ones must be discarded and replaced by new ones

5. Undo the nuts securing the bumper. The lower bolts have nuts only if the car is equipped with a towbar attachment.


6. Together with an assistant, pull out the bumper from the edges of the wheel housings and lift the bumper out backwards.

Note

For cars equipped with Saab Parking Assistance (SPA):

Undo the connector in the bumper.


Important

Be careful to avoid damaging the paintwork.



To fit



1. Place the bumper in position and press it over the edges of the wheel housings. Make sure it is in the correct position along the guides in the rear wings.

2. Tighten the nuts by hand.

3. Position the bumper correctly and tighten the screws in the edge of the wheel housing.


4. Tighten the retaining nuts.

5. Fit the new insulation pads.


6. Refit the storage compartments.

7. Close the tailgate and check the fit of the bumper against the tailgate.