SAAB WIS ONLINE

Engine oil and oil filter

Engine oil and oil filter


Checking for oil leaks

Check that no oil leaks from the top or bottom of the engine and gearbox or the power steering's hydraulic system.

If there is an oil leak on the auxiliaries side of the engine, it is recommended that the drive belt is inspected and replaced if necessary.

Engine oil


Change the oil. Fill to the MAX mark. The distance between the MAX and MIN marks is equivalent to 1 litre (1.05 qts).

Check the level while the engine is warm, 2-5 minutes after it has been turned off.

Oil capacity

B205E, B235E: 4.0 litres (4.3 qts) including filter

B308E: 4.5 litres (4.8 qts) including filter

Oil type

See Lubrication, lubricants .

Tightening torque, drain plug:

B205E, B235E, B308E: 25 Nm (19 lbf ft)

Check the oil level after changing the engine oil and oil filter.


Oil filter



1. Slacken the oil filter with the filter wrench and unscrew it. Clean the sealing surface on the engine.

2. Oil in the new oil filter's rubber gasket and fit it in place. Tighten the filter by hand.

3. Start the engine and check the filter for leaks.