Fuel pressure regulator, V6
|
|
Fuel pressure regulator, V6
|
Warning
|
|
Removal of the fuel pressure regulator involves partial dismantling of the car's fuel system. The following points must therefore be observed in connection with this work:
|
|
•
|
Work only in a well-ventilated area. If approved equipment for the extraction of fuel vapour is available, be sure to use it.
|
|
•
|
Wear suitable gloves. Prolonged contact with fuel can cause skin irritation or dermatitis.
|
|
•
|
Keep a class BE fire extinguisher near at hand. Be mindful of the danger of sparks caused by short circuits and when connecting and disconnecting leads in electrical circuits.
|
|
•
|
No smoking anywhere in the vicinity,
|
|
•
|
Wear protective goggles.
|
|
|
|
|
|
|
1.
|
Reduce fuel pressure by removing fuel pump fuse no. 19 while the engine is idling. Turn off the ignition once the engine has stopped and replace the fuse.
|
|
2.
|
Remove the engine cover.
|
|
3.
|
Remove the vacuum hose.
|
|
4.
|
Loosen the clamp and remove the regulator carefully. Keep an absorbent cloth or paper nearby to take care of any fuel spills.
|
|
Important
|
|
Lubricate the O-ring with non-acidic vaseline before fitting.
|
|
|
|
1.
|
Fit the regulator and tighten the clamp.
|
|
2.
|
Connect the vacuum hose.
|
|
3.
|
Make sure the system is not leaking.
|
