Charge air pipe V6

/ 9-5 (9600) / 2001 / 2. Engine / Intake system / Adjustment/replacement / Charge air pipe V6

To remove

1.	Remove the engine cover.

2.	Remove the bypass pipe with valve, keeping the O-ring from the connection to the turbocharger inlet pipe.

3.	Unplug the connector from the temperature/pressure sensor on the charge air pipe.

4.	Detach the charge air pipe from the throttle body.

5.	Raise the car.

6.	Detach the charge air pipe from the charge air cooler leaving the clip to hang on the cooler.

7.	Lower the car to the floor.

8.	Remove the charge air pipe.

To fit

1.	Fit the charge air pipe.

2.	Raise the car.

3.	Fit the charge air pipe to the charge air cooler with the clip.

4.	Lower the car to the floor.

5.	Connect the charge air pipe to the throttle body.

6.	Plug in the connector for the temperature/pressure sensor on the charge air pipe.

7.	Fit the bypass pipe with valve using a new O-ring for the connection to the turbocharger inlet pipe.

8.	Fit the engine cover.

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.