Before changing the turbo unit
|
|
Before changing the turbo unit
|
|
1.
|
Raise the car, place a receptacle under the car and drain the oil via the drain plug in the oil sump. Refit the drain plug.
|
|
2.
|
Lower the car and fill with oil to the MAX mark. The distance between the marks corresponds to a volume of 1 litre (1.05 qts).
|
|
3.
|
Start the engine and let it idle until the thermostat opens (radiator fan starts).
|
|
4.
|
Raise the car and drain the oil. Refit the drain plug.
Tightening torque: 25 Nm (19 lbf ft)
|
|
5.
|
Undo the oil filter using the filter wrench and remove the filter. Wipe clean the surface sealing on the engine.
|
|
6.
|
Oil the rubber gasket on the new oil filter and fit it. Tighten the filter by hand.
|
|
7.
|
Lower the car and fill with oil to the MAX mark. The distance between the marks corresponds to a volume of 1 litre (1.05 qts).
|
|
8.
|
Make sure there are no oil leaks after starting the engine.
|
Oil capacity
4.0 litres (4.3 qts) including filter
Oil type
See
Lubricants
