SPA control module, 4D
SPA control module, 4D |
1. |
Open the left-hand rear door and tip forward the 60% part of the rear seat (seat cushion and backrest).
|
2. |
Loosen the door weather seal so that the side trim by the wheel housing is free
|
3. |
Remove the upper front clip of the side trim.
|
4. |
Bend aside the side trim.
|
5. |
Remove the sound absorbing cushion.
|
6. |
Loosen but do not remove the 2 control module retaining screws.
Move the control module upwards and backwards so that the screws come out of the slots. |
7. |
Undo the 2 connectors and remove the control module.
|
To fit |
1. |
Plug in the 2 connectors, grey to grey and black to black. Fit the screws into the slots, making sure that the washers are in front of the mounting plate. Tighten the screws.
|
2. |
Fit the sound absorbing cushion.
|
3. |
Refit the side trim and secure with the clip.
|
4. |
Press the door weather seal into place.
|
5. |
Raise the rear backrest and lower the seat cushion.
|