SAAB WIS ONLINE

Wiring harness, rear 5D

Wiring harness, rear 5D


Replacement

Note

If the car is equipped with a radio other than a genuine Saab radio, check that the customer has the radio code before commencing work.

Disconnect the negative battery cable.



1. Remove the cover on the LH A-pillar.

2. Lower the headlining.

3. Remove:

• cover on LH front side trim

• LH front side trim

• front seats

• glove box and RH front side trim

• B-pillar covers

• centre panel and floor console

• rear seat with backrest, lift up carpets

• panels in luggage compartment

• LH side bolster

• trim on LH D-pillar

• load sill

4. Lower the fuel tank a bit.

5. Mark all the connectors accurately before unplugging them from their respective components.

6. Disconnect the cables on the grounding points.

7. Unplug the connectors to the other wiring harnesses.

8. Carefully remove the wiring harness without damaging cable ties, etc., that are to be refitted.

9. Lay out the new wiring harness the same as the old one and secure it in the same way. Make sure all grommets are sealing tight.

10. Plug in the connectors to their respective components. If in doubt refer to wiring diagrams/component lists for the respective system.

11. Plug in the connectors.

12. Connect the ground cables.

13. Refit all dismantled parts.

14. Connect the negative battery cable. Set the clock.


Important

Secure the wiring harness to prevent the risk of chafing and rattling.

Check all rubber seals to minimize the risk of leakage.


Note

Spray all the connectors with “Kontakt 61” to prevent copper rust from forming. Clean all the grounding points and apply them with Vaseline.