Gear selector position sensor - gear engaged
| Gear selector position sensor - gear engaged |
The gear selector position sensor is a position switch that is powered via +15. A number of slip contacts power the sensor outputs. The combination of terminals A, B, C and PA indicate the current selector lever position (see table). The slip contacts can be either closed (ON) or open (OFF).
|
|
A
|
B
|
C
|
PA
|
|
P
|
ON
|
OFF
|
OFF
|
ON
|
|
R
|
ON
|
ON
|
OFF
|
OFF
|
|
N
|
OFF
|
ON
|
OFF
|
ON
|
|
D
|
OFF
|
ON
|
ON
|
OFF
|
|
3
|
ON
|
ON
|
ON
|
ON
|
|
2
|
ON
|
OFF
|
ON
|
OFF
|
|
1
|
OFF
|
OFF
|
ON
|
ON
|
The following table describes the relationship between the gear selector position sensor internal terminals A, B, C and PA, the pins in the connector H10-1 and the control module.
|
Gear selector position sensor terminals
|
A
|
B
|
C
|
PA
|
|
Connector H10-1, pin
|
1
|
2
|
3
|
4
|
|
Control module, pin
|
2
|
24
|
3
|
25
|
To ensure that the control module receives accurate information, it is important for the sensor to be correctly adjusted. Special tool 87 92 467 should be used for adjusting the sensor.
Diagnostics
In the event of a fault in the selector lever position inputs, diagnostic trouble code P0705 will be generated and the transmission will go into Limp-Home mode.This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
