SAAB WIS ONLINE

Sealing ring - selector rod, gearbox removed, VIN 43501882

Sealing ring - selector rod, gearbox removed, VIN 43501882

To remove


1. Prise out the seal using a narrow screwdriver.


Important

Do not damage the sealing surface on the selector rod.



To fit



1. Clean the selector rod and check that it has no burrs.

2. Wind a layer of thin, smooth plastic tape around the hole in the selector rod.

3. Lubricate the gear selector rod and fit the seal. Remove the tape and tap in the seal using 87 90 685 Fitting tool and 87 91 709 Clamp . Tap only as far as the seal is flush with the clutch housing.