SAAB WIS ONLINE

(801-2288) Defective flange seal on underside of bonnet

MODIFICATION INSTRUCTION
Bulletin Nbr: 801-2288
Date: ........... AprilĀ 2001
Market: all
Defective flange seal on underside of bonnet


Service campaign 157 01

Cars in stock must be remedied before delivery.

Cars already delivered must be rectified in connection with a scheduled visit to the garage for service or repairs.

Cars affected

Saab 9-5 M01 within VIN interval 13037755-13038502.

Background

The flange sealant on the underside of the bonnet has been applied incorrectly. The seal has come unstuck from the bonnet in two places: on the left-hand rear edge of the bonnet by the wing, and on the right-hand rear edge of the bonnet by the A-pillar.

Parts required

16-30 15 815 Cleaner, Teroson FL T875, sufficient for approx. 100 cars

16-30 07 093 Sealant, Terostat 1K-PUR T226, sufficient for approx. 30 cars

400 108 429 Touch-up pen 268 Silver

400 108 460 Touch-up pen 257 Midnight Blue

400 108 569 Touch-up pen 153 Cirrus White

400 108 635 Touch-up pen 170 Black

400 108 874 Touch-up pen 264 Cosmic Blue

400 126 827 Touch-up pen 273 Sun Green

400 129 185 Touch-up pen 279 Steel Grey

400 129 193 Touch-up pen 278 Laser Red



Procedure

Check box A4 on the modification identity plate before proceeding. Continue as follows if the box is not marked.


1. Open the bonnet.

2. Clean both sides using Teroson FL T875. Allow to dry thoroughly.

3. Apply sealant to the left-hand side of the bonnet behind the existing seal as illustrated.


4. Spread the sealant out into a thin, even layer.

5. Apply sealant to the right-hand side of the bonnet behind the existing seal as illustrated.


6. Spread the sealant out into a thin, even layer.

7. Allow the sealant to dry for five minutes.

8. Cover the area below the bonnet before touching up the paintwork.

9. Paint the area with a touch-up pen.

10. Allow the paint to dry for at least 5 minutes. If necessary, apply another coat of paint.

11. Remove the cover.

12. Close the bonnet.


Marking the modification identity plate

On completion of the necessary measures, box A4 on the modification identity plate must be marked. If the work was carried out by the importer, mark the box with a "7". If done by a dealer, mark it with an "8".

Time/Warranty information

See separate information.