Outer tailgate handle, 5D
|
|
Outer tailgate handle, 5D
|
|
1.
|
Remove the outside screws.
|
|
2.
|
Open the tailgate.
|
|
3.
|
Remove the frame around the inner door handle by prising with a screwdriver in the three recesses. Once the frame clips have been released, pull the frame down and bend it out.
|
|
4.
|
Remove the inner tailgate trim by removing the door pull retaining screws and the plastic clips in the trim.
|
|
5.
|
Lift off the tailgate trim as described below:
|
|
|
5.a.
|
Pull down the top of the trim to release it from the clips.
|
|
|
5.b.
|
Pull back on the trim to release the guide pin at the door pull, taking care not to break it.
|
|
6.
|
Remove both light clusters in the tailgate and the number plate, if any.
|
|
8.
|
Remove the locking rod and unplug the connector.
|
|
9.
|
Unsnap the clips and remove the lock together with the number plate lighting.
|
|
1.
|
Insert the wiring harness and lock arm into the lock opening.
|
|
2.
|
Press on the handle and number plate lighting to the tailgate.
|
|
3.
|
Screw in the screws on the outside.
|
|
4.
|
Screw on the nuts.
|
|
5.
|
Fit the lock rod and plug in the connector. Fit the connector into the holder.
|
|
6.
|
Check the rubber seal and fit the light cluster to the tailgate. Fit the number plate if it was removed.
|
|
7.
|
Plug in the connectors.
|
|
8.
|
Fit the inner trim by inserting the clip at the door pull and fastening with the clips. Screw in the two door pull screws.
|
|
9.
|
Fit the frame around the inner door handle.
|
