Centre console
Centre console |
1. |
Manual gearbox:
Lift up the gear lever gaiter. Automatic transmission: Remove the edging using 82 93 474 Removal tool . |
2. |
Remove the compartment or ashtray with holder using a screwdriver and
82 93 474 Removal tool
. See
Ashtray
.
|
3. |
Remove the gear lever cover, 2 screws.
|
4. |
Unplug the connector for the central locking system switch.
|
5. |
Lift up the gear lever gaiter and undo the connectors for the seat heating, seat ventilation and cigarette lighter switches.
|
6. |
Remove the rear section of the centre console by removing the screw on the top. Then lift straight up and unplug the connector.
|
7. |
Select reverse (manual) or P (automatic) and remove the key.
|
8. |
Rotate and lift up the theft protection antenna unit (bayonet fitting) from the ignition switch and unplug the connector.
Insert the key and select neutral. |
9. |
Disconnect the switch for the electric window lifts and unplug the connectors.
|
10. |
Remove the screws holding the upper part of the centre console, 6 screws.
Lift out the upper part of the centre console. |
11. |
Fold back the carpets and remove the front screws, 2 pcs.
|
12. |
Remove the rear screws, 2 pcs.
|
13. |
Lift and remove the centre console.
|
To fit |
1. |
Lift the centre console into place.
|
2. |
Screw on the centre console front and back, 4 screws. Start with the one at the front left, which is used as a guide.
|
3. |
Refit the carpets.
|
5. |
Screw the upper part of the centre console in place, 6 screws.
|
6. |
Refit the switch for the electric window lifts and clip the handbrake gaiter back into place.
|
7. |
Plug in the connectors in the rear section of the centre console and fit the rear section. Fit the upper screw.
|
8. |
Reconnect the central locking system connector.
|
9. |
Plug in the connector for the seat heating, seat ventilation and cigarette lighter switches.
|
10. |
Refit the gear lever cover, 2 clips at the back and 2 screws at the front.
|
11. |
Refit the compartment or ashtray with holder.
|
12. |
Manual gearbox:
Refit gear lever gaiter. Automatic gearbox: Fit the rim around the gear lever housing. |
13. |
Select reverse (manual) or P (automatic) and remove the key.
|
14. |
Plug in the connector for the theft-protection antenna unit and fit it (bayonet fitting).
|