Camshaft cover
Camshaft cover |
To remove |
1. |
Remove the upper engine cover.
|
2. |
Remove the turbocharger delivery pipe from the camshaft cover and the turbocharger, and detach the crankcase ventilation hose from the camshaft cover. Plug the turbocharger inlet.
|
3. |
Move the fuel lines away form the camshaft cover.
|
4. |
Undo the rear cable harness mounting on the camshaft cover and unplug the pressure/temperature sensor connector.
|
5. |
Remove the camshaft cover.
|
To fit |
1. |
Clean the camshaft cover sealing surfaces from any gasket remnants. Position a new gasket on the camshaft cover. Apply
87 81 841 Silicon flange sealant
to the sealing surface, see illustration.
|
2. |
Position the camshaft cover on the cylinder head and tighten the bolts.
Tightening torque: 8 Nm (6 lbf ft). |
3. |
Fit the rear cable harness mounting on the camshaft cover and plug in the pressure/temperature sensor connector.
|
4. |
Move the fuel lines back to the camshaft cover.
|
5. |
Remove the plug and fit the turbocharger delivery pipe to the turbocharger and camshaft cover.
|
6. |
Connect the crankshaft ventilation hose to the camshaft cover.
|
7. |
Fit the upper engine cover.
|