SAAB WIS ONLINE

Fuel pump, auxiliary heater, 4-cyl

Fuel pump, auxiliary heater, 4-cyl

Warning

Removal of the fuel filter involves partial dismantling of the car's fuel system. The following points must therefore be observed in connection with this work:



• Work only in a well-ventilated area! If approved equipment for the extraction of fuel vapours is available, be sure to use it.

• Wear suitable gloves! Prolonged contact with fuel can cause skin irritation or dermatitis.

• Keep a class BE fire extinguisher near at hand! Be mindful of the danger of sparks caused by short circuits and when connecting and disconnecting leads in electrical circuits.

• No smoking anywhere in the vicinity.


Important

Be particulary observant regardning cleanliness when working on the fuel system. Loss of function may occur due to very small particles. Prevent dirt and grime from entering the fuel system by cleaning the connections and plugging pipes and lines during disassembly. Use 82 92 948 Plugs, A/C system assembly. Keep components free from contaminants during storage.


To remove


1. Raise the car and place a receptacle under the fuel filter holder.

2. Remove the fuel pump from the rubber mounting.


3. Detach the connector and the fuel lines from the fuel pump. Plug the lines.



To fit


1. Replace the rubber mounting as necessary.

2. Attach the connector and fuel lines to the pump.


3. Fit the fuel pump.

4. Connect an exhaust evacuator to the exhaust pipe of the engine and the auxiliary heater and lower the car.


5. Start the engine and start the auxiliary heater using the diagnostics tool. Check the function of the heater.