SAAB WIS ONLINE

P0403, P0404, P1404

Read the instructions below then start the fault diagnostic procedure.

Symptom: CHECK ENGINE lamp on. Loss of performance. Limp home.

P0403, P0404, P1404


P0403 EGR Valve PWM Signal Circuit. Short to Ground.

P0404 EGR Valve PWM Signal Circuit. Short to B+.

P1404 EGR Valve PWM Signal Circuit. Open Circuit.


Fault symptoms


CHECK ENGINE lamp on.

Loss of performance.

Limp home.


Conditions

The following conditions apply for this DTC:


P0403: EGR circuit shorted to ground for more than 0.6 seconds.

P0404: EGR circuit shorted to B+ for more than 0.6 seconds.

P1404: Open circuit in EGR circuit for more than 0.6 seconds.


Diagnostic help




P0403: This DTC indicates an electrical fault in the EGR circuit. The control module uses a 50% PWM signal as a substitute value for EGR control. The control module uses a 2% PWM signal for boost pressure control. The read value on the diagnostic tool is equal to the substitute value.

P0404: This DTC indicates an electrical fault in the EGR circuit. The control module uses a 50% PWM signal as a substitute value for EGR control. The read value on the diagnostic tool is equal to the substitute value.

P1404: This DTC indicates an electrical fault in the EGR circuit. The control module uses a 50% PWM signal as a substitute value for EGR control. The read value on the diagnostic tool is equal to the substitute value.

Note

A fault in the control module female connector can cause a trouble code. Check the contact for a bent pin, oxidation and tightness of pins. See Difficult faults in PSG16 despite trouble code