SAAB WIS ONLINE

P1631

Read the instructions below then start the fault diagnostic procedure.

Symptom: CHECK ENGINE. Possible loss of power before trouble code generated.

P1631


Internal Control Module. Malfunction.


Fault symptoms


CHECK ENGINE.

Possible loss of power before trouble code generated.


On-Board Diagnostics

Type of diagnosis:


- Continuous. But interrupted when fault criteria fulfilled and will not restart until next driving cycle.


Enable criteria:


- Crankshaft stationary, even after ignition OFF. Car stationary. The other two absolute pressure sensors deviate less than 10 kPa from each other.


Fault criteria:


- Sensor value deviates more than 15 kPa from charge air absolute pressure sensor or intake air absolute pressure sensor.


Dependents:


- P0336 and P0337.


System reaction to a fault:


- Starting charge air pressure value used as substitute value. Purge blocked. All diagnoses that have the general condition that the atmospheric pressure must exceed 72 kPa and the engine coolant and intake air temperature must exceed -7°C, are blocked.


OK report:


- Fault criteria for P1631, P1632 or P1633 not fulfilled.


Fault handling: (See section Fault handling III, other emission-related components and functions for more information.)


- Type III.


Diagnostic help

Fault diagnosis concerns an electrical fault in connecting leads or in the sensor.

Functions in the diagnostic tool related to the fault:


Diagnostic status for the diagnosis.

Pressure sensor value, unit kPa.


With the engine stationary, the value should correspond with the two other pressure sensors. Accepted difference is 10 kPa.

See also the description of readings under Menu "Read Values" for more information.

See P0605 .