Rear window wiper 5D
Rear window wiper 5D |
To remove |
1. |
Remove the wiper arm.
|
2. |
Remove the window cover plates.
|
3. |
Remove the frame around the inner lock handle.
|
4. |
Remove the inner tailgate trim by undoing the screws securing the door pull and the plastic clips in the trim.
|
5. |
Pull down the top of the trim so that it comes away from the clips and then pull it backwards to release the clip by the door pull.
|
6. |
Unplug the connector.
|
7. |
Remove the three retaining screws.
|
8. |
Detach the washer hose.
|
9. |
Take out the wiper motor.
|
10. |
Remove the motor from the bracket.
|
To fit |
1. |
Fit the motor to the bracket.
|
2. |
Fit the wiper motor and tighten the screws.
|
3. |
Plug in the connector and attach the washer hose.
|
4. |
Fit the wiper arm. The mark on the rubber seal should be pointing left.
|
5. |
Check the function, wiper parking position and washer operation.
|
6. |
Fit the inner trim by inserting the clip by the door pull and fasten to the clips. Screw in the two screws in the door pull.
|
7. |
Fit the frame around the inner handle.
|
8. |
Fit the window cover plates.
|