Engine management system, V6 diesel from Rev.1 (Part 3/3)
Engine management system, V6 diesel from Rev.1 (Part 3/3) |
List of components |
No. | Name Location | Illus. |
Components |
||
202
|
Temperature sensor, coolant,
on coolant pipe on LH side of engine |
|
206a
|
Injector cylinder 1,
on top of rear cylinder bank |
|
206b
|
Injector cylinder 2,
on top of front cylinder bank |
|
206c
|
Injector cylinder 3,
on top of rear cylinder bank |
|
206d
|
Injector cylinder 4,
on top of front cylinder bank |
|
206e
|
Injector cylinder 5,
on top of rear cylinder bank |
|
206f
|
Injector cylinder 6,
on top of front cylinder bank |
|
243
|
Level monitor, engine oil,
above oil sump gasket |
|
408
|
Engine speed sensor,
on RH side of engine by crankshaft pulley |
|
555
|
Camshaft position sensor,
on RH side of front cylinder bank |
|
603
|
Pressure sensor, charge air,
on rear cylinder bank intake manifold |
|
606A
|
EGR control valve,
on RH side of engine between cylinder banks (lower connector) |
A
B |
651
|
Temperature sensor, fuel,
on rear cylinder bank by vacuum pump |
|
652a
|
Fuel pressure control valve, common rail,
lower valve on rear end of fuel pump |
|
652b
|
Fuel pressure control valve, common rail,
upper valve on rear end of fuel pump |
|
653
|
Fuel pressure sensor, common rail,
on LH side of common rail |
|
654
|
Position sensor, turbocharger guide rails,
in turbocharger vacuum unit |
|
655A
|
Control module, V6 diesel, connector A
in assembly (cabin side) in front of windscreen on passenger side |
|
655B
|
Control module, V6 diesel, connector B,
in assembly (cabin side) in front of windscreen on passenger side |
|
656A
|
Power stage, injectors, connector A,
behind glove box |
|
656B
|
Power stage, injectors, connector B,
behind glove box |
|
|
6-pin connector |
|
H6-5
|
By EGR valve
|
|
|
42-pin connector |
|
H42-5
|
In centre of bulkhead partition (engine bay side)
|
|
|
Crimp connections |
|
J25
|
Approx. 80 mm from branching point camshaft position sensor towards connector H42-5
|
|
J26
|
Approx. 50 mm from engine control module connector B towards connector A
|
|
J27
|
Approx. 120 mm from branching point camshaft position sensor towards connector H42-5
|
|
J29
|
LHD:
Approx. 180 mm from branching point connector H42-5 towards grounding point G7
RHD: Approx. 355 mm from connector H42-5 towards grounding point G7 |
|
J33
|
LHD:
Approx. 220 mm from branching point connector H42-5 towards grounding point G7
RHD: Approx. 395 mm from connector H42-5 towards grounding point G7 |
|
J34
|
Approx. 40 mm from branching point camshaft position sensor towards connector H42-5
|
|