SAAB WIS ONLINE

Differential

Differential

Replacement of bearing


To remove


1. Secure the differential in a vice with protective jaws and pull off the bearings with puller 87 92 343. Use tool 87 91 659 as support.


To fit



1. Press down the bearings until they stop with press sleeve 87 92 475. . Use tool 87 92 210 as support.

2. To change bearing race, see


Replacement of final drive gear

To remove



1. Remove the final drive gear bolts using an external torx and tap off the final drive gear using a plastic hammer.


To fit



1. Tap on the final gear wheel on the differential housing using a plastic hammer.

2. Fit the final drive gear with the mark towards the differential housing. Fit new bolts and tighten alternately. Coat the bolts with Thread locking adhesive, Loctite 270 . It may be necessary to heat the gear before assembling.

Tightening torque 20 Nm+90° (15 lbf ft+90°)