Springs
Springs |
1. |
Remove the MacPherson strut and clamp it in a vice.
Compress the spring using Spring compressor 88 18 791 and Holder 88 18 817 . |
2. |
Grip the piston rod to prevent it from turning and remove the nut, using tool 89 96 613. The nut is of self-locking type and must not be reused.
|
3. |
Remove the bearing and upper spring seat.
|
4. |
Remove the spring, rubber gaiter and compression stop.
|
To fit |
1. |
Mount the compression stop, spring seat and rubber gaiter and then fit the spring.
|
2. |
Make sure that the lower end of the spring abuts against the stop in the lower spring seat.
|
3. |
Fit the upper bearing.
|
4. |
Tighten the nut.
Tightening torque 105 Nm (76 lbf ft). |
5. |
Release the spring compressor and fit the MacPherson strut.
|