SAAB WIS ONLINE

Ventilation fan control (V6 Diesel)

Ventilation fan control (V6 Diesel)

To remove


1. Put the recirculation flap in OFF position and the ignition in LOCK.


2. Remove the glove box and side trim on the centre console, see Glove box .


3. Loosen the two front connectors above the filter cartridge.

Unplug the contacts from the plate and cut the cable tie.

4. Remove the lower panel from the driver's side, 3 screws.


5. Remove the data link connector, 2 screws, and detach the leads to the floor lighting.

6. Unplug the connector to the accelerator pedal potentiometer.


7. Remove the nuts holding the accelerator pedal.

8. Remove the water shield over the ventilation fan control.

9. Remove the wiper arms with special tool 85 80 144 Puller, windscreen wiper arm .


10. Remove the rubber seals from the wiper spindles.

11. Loosen the rubber moulding along the edge of the bulkhead in the middle only. Leave the outer clips in place.

12. Loosen the cover over the bulkhead partition space (fastened with clips) by lifting it carefully forwards so that it is released from the windscreen.

Move the wire to the bonnet to one side.

Note

Take care when remove the clips.


13. Loosen the clips holding the front edge of the water shield with a screwdriver. Lift off the water shield.


14. Press down the wiring harness on the other side, including the rubber seal to the control unit.


15. Remove the ventilation fan control and pull out the wiring harness.



To fit


1. Fit the ventilation fan control with water shield.


2. Pull out the wiring harness of the fan housing.

3. Remove the nuts holding the accelerator pedal.


4. Attach the connector to the pedal potentiometer.

5. Attach the connector to the floor lighting.


6. Fit the lower panel with air duct.

7. Fit the data link connector (2 bolts).

8. Insert the wiring harness to the ventilation fan through the protective cover. Observe the foam seal in the hole.

9. Attach the connector and fit a new cable tie for the ventilation fan.

Check that the wiring harness is not in contact with the fan motor or the air recirculation flap.


10. Insert the wiring harness through the hole in the fan housing into the cabin and fit the rubber seal.

11. Fit the water shield (fastened with 3 clips on the front edge).


12. Insert the cover over the bulkhead partition space from the rear, against the windscreen. Hold the wire to the bonnet to one side and then place it in its groove.


Note

Take care when remove the clips.


13. Fit the rubber strip on the front edge of the bulkhead.

14. Fit the rubber seals on the wiper spindles.

15. Fit the wiper arms.

16. Fit the contacts on the plate above the filter and fixate the wiring harness with a cable tie.


17. Plug in the connectors above the filter.


18. Fit the glove box and side trim on the centre console, see Glove box .