Sunroof hatch (Glass hatch)
| Sunroof hatch (Glass hatch) |
| 1. |
Open the sunroof hatch so that the cover strip retaining screws are accessible.
|
|
| 2. |
Remove the four screws holding the cover strip.
|
|
| 3. |
Close the hatch and tilt the rear edge.
|
|
| 4. |
Remove the rear edge of the cover strip by pulling it towards the centre of the car so that the clips come undone. Pull the cover strip out through the rear edge of the hatch. Be careful not to scratch the roof.
|
|
| 5. |
Remove the cover strips over the screws on the left and right-hand sides of the sunroof hatch. The strips are secured with clips, pull them straight towards the centre of the car.
|
|
| 6. |
Raise the rear of the hatch.
|
|
| 7. |
Undo the four glass hatch retaining screws.
|
|
| 8. |
Lift off the glass hatch.
|
|
| Fitting |
| 1. |
Put the sunroof hatch in position.
|
|
| 2. |
Screw in the four retaining screws without tightening them.
|
|
| 3. |
Close the hatch.
|
|
| 4. |
Adjust the hatch so that it is lying flush with the edges of the roof.
|
||||||||||
| 5. |
Tighten the screws.
|
|
| 6. |
Fit the two covers over the screws.
|
|
| 7. |
Open the rear of the hatch so that the cover strip can be fitted.
|
|
| 8. |
Press home the clips on the rear edge of the cover strip.
|
|
| 9. |
Close the rear edge of the hatch and open the hatch slightly so that the screws become accessible. Tighten the screws.
|
|
| 10. |
Close the hatch and tilt the rear edge.
|
|
| 11. |
Check that the clips remain in place on the rear edge.
|
|
| 12. |
Check the function.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
