SAAB WIS ONLINE

P1404

Read the instructions below then start the fault diagnostic procedure.

Symptom: Abnormal idle.

P1404


EGR position sensor, High. Performance Problem.


Fault symptom


Abnormal idle.


On-Board Diagnostics

Type of diagnosis:


- Continuous.


Enable criteria:


- Battery voltage: 10.2-15.8 V.

- P1636 or P1637 must not be detected.

- The difference in engine speed from two measurements must not exceed 40 rpm.

- The difference between two injections must not exceed 1.5 mm 3 /C.

- EGR flow should be more than 26 %.

- These conditions must be fulfilled for 3 seconds before diagnostics run.


Fault criteria:


- EGR position is 3.5 mm higher than desired for 33 sec.


Dependents:


- None.


System reaction to a fault:


- EGR is switched off.


OK report:


- Fault criteria not fulfilled.


Fault handling: (See section Fault handling III, other emissions-related components and functions for more information)


- Type III.


Diagnostic help

Fault diagnosis concerns an electrical fault in connecting leads or in the sensor.

Functions in the diagnostic tool related to the fault:


- Read values: Target EGR Valve Position, EGR Valve Position. EGR PWM signal

- The EGR function is switched off after 1 minute of idling (EGR valve closed). As soon as the accelerator pedal is touched, EGR control is reactivated.


See also the description of read values under Menu "Read values" for more information.

Checking the wiring harness

Jiggle the wiring harness at several points and in different directions to detect intermittent breaks and short circuits. Observe the multimeter, diagnostic tool or test lamp during the check.