Test readings, control module connections
|
Test readings, control module connections
|
The following pages contain values and instructions for measuring signals and levels on the ECD U2P control module.
•
|
Note the test readings, use common sense when assessing the results of the tests.
|
•
|
The specified values are with the ignition in the ON position unless otherwise stated.
|
•
|
First, make sure the control module is supplied with power and grounded.
|
•
|
Then, check all the sensor inputs and signals from other systems.
|
•
|
Finally, check the control module outputs. Remember that the test readings do not indicate whether the actuator is working.
|
•
|
If any of the test readings are incorrect, use the wiring diagram to determine which lead, connector or component should be checked further.
|
•
|
The specified test values apply for a Fluke 88/97.
|
•
|
The test readings % (+) and ms (+) signify the pulse ratio and pulse length of the signal respectively. A test instrument capable of measuring pulse ratio and pulse width must be used. The sign indicates a positive trigger pulse, TRIG+.
|
>= greater than; <= less than;
»
= approximately equal to; ∼= alternating current
Pins without further comments have no connection. (LP: LOGIC PROBE P = select pulse; p = visible pulses).
Pin
|
Cable colour
|
Component/function
|
In/Out
|
Test conditions
|
Across
|
Test reading
|
See
|
1
|
|
|
|
|
|
|
|
2
|
|
|
|
|
|
|
|
3
|
|
|
|
|
|
|
|
4
|
|
|
|
|
|
|
|
5
|
|
|
|
|
|
|
|
6
|
|
|
|
|
|
|
|
7
|
|
|
|
|
|
|
|
8
|
|
|
|
|
|
|
|
9
|
|
|
|
|
|
|
|
10
|
|
|
|
|
|
|
|