SAAB WIS ONLINE

Front silencer

Front silencer

To remove


1. Raise the car.


2. Loosen the nuts at the joint between the front and rear of the exhaust system.

3. Remove the rubber mounting lock clips.

4. Remove the two front rubber mountings and place, for example, the jack of the lift under the end of the pipe.


5. Remove the remaining rubber mounts and lower the exhaust system.


Note

If the system is divided before the last silencer, loosen the exhaust clamp of the rear silencer and divided the system there.


To fit

Note

The rubber mountings can be lubricated with acid-free petroleum jelly to facilitate fitting.



1. Fit the rubber mountings, lift up the exhaust system and fit it in place. Adjust the system so that it does not break/buckle or lie against anything.

For cars with visible tailpipe: adjust so that the tailpipe is centred in the cut-out.

2. Fit the rubber mounting lock clips.

3. Fit the nuts at the joint between the front and rear of the exhaust system.

Tightening torque: 22 Nm (16 lbf ft)