P0106
Read the instructions below then
start the fault diagnostic procedure.
Symptom: CHECK ENGINE.
Engine speed drops slower than normal when accelerator pedal is released.
Misfiring can occur before trouble code is generated.
Manifold Absolute Pressure Sensor Circuit. Performance Problem.
Fault symptoms
|
•
|
Engine speed drops slower than normal when accelerator pedal is released.
|
|
•
|
Misfiring can occur before trouble code is generated.
|
On-Board Diagnostics
Type of diagnosis:
|
-
|
Continuous. But interrupted when fault criteria fulfilled and will not restart until next driving cycle.
|
Enable criteria:
|
-
|
General conditions for this trouble code: Atmospheric pressure must exceed 72 kPa and the engine coolant and intake air temperatures must exceed -7°C.
|
|
-
|
Test 1: Crankshaft stationary, even after ignition OFF. Car stationary. The difference in pressure between the other two absolute pressure sensors in the system less than 10 kPa.
|
|
-
|
Test 2: Engine running. Engine speed above 1300 rpm. Engine load lower than 110 mg/c. Accelerator pedal fully released.
|
Fault criteria:
|
-
|
Test 1: Sensor value differs more than 15 kPa from atmosphere absolute pressure sensor.
|
|
-
|
Test 2: Sensor value exceeds 50 kPa.
|
Dependents:
System reaction to a fault:
|
-
|
Purging is blocked. Correction of air mass/combustion for fuel calculation is blocked. Charge air adaptation is blocked and reset.
|
OK report:
|
-
|
Test 1 and Test 2 performed once and fault criteria not fulfilled. Fault criteria for P0107 or P0108 not fulfilled.
|
Fault handling:
(See section
Fault handling III, other emission-related components and functions
for more information.)
Diagnostic help
Fault diagnosis concerns a fault in the sensor. A major vacuum leak can generate the trouble code.
Functions in the diagnostic tool related to the fault:
|
•
|
Pressure sensor value, unit kPa. The value should correspond with the other two pressure sensors when the engine is stationary. Accepted difference is 10 kPa.
|
See also the description of readings under
Menu "Read Values"
for more information.
