Preheated Oxygen Sensor 1. OBDll
|
Preheated Oxygen Sensor 1. OBDll
|
1.
|
Separate the oxygen sensor connector and remove it from the bracket.
|
3.
|
Cut off the cable tie securing the oxygen sensor cable. Note how the cables are positioned and lower the cable. Remove the oxygen sensor.
Important
|
The cables must not be twisted. Twisted cables exposed to vibration can break.
|
The oxygen sensor is sensitive to impacts and jolting and must be handled with care.
|
|
|
Important
|
The cables must not be twisted. Twisted cables exposed to vibration can break.
|
The oxygen sensor is sensitive to impacts and jolting and must be handled with care.
|
|
Note
|
Coat the oxygen sensor threads sparingly with Molykote 1000 (part no. 30 20 971).
|
1.
|
Fit the oxygen sensor.
Tightening torque: 55 Nm (40.5 lbf ft)
|
2.
|
Carefully replace the cable to the oxygen sensor connector. Secure the cable with a cable tie.
Important
|
Chemicals such as contact spray and grease must not come into contact with the oxygen sensor connectors.
|
|
|
3.
|
Attach the connector to the holder and connect the oxygen sensor's connector. Lower the car.
|