Headlamps
Headlamps |
To remove |
1. |
Remove the centre grille as follows:
|
1.A. |
Lift slightly to release the bottom edge.
|
1.B. |
Pull it down and forwards to release the spring clip.
|
2. |
Remove the side grille from the back by bending up the lower clips to release them. Lift away the side grille.
|
3. |
LH:
Remove the top of the battery cover.
|
4. |
Press down the snap fastener and detach the direction indicator.
|
5. |
Unplug the direction indicator connector and remove the direction indicator.
|
6. |
Remove the protective cover on the lamp to facilitate removing the headlamp.
|
7. |
Remove the screws and clip.
|
8. |
Lift out the headlamp slightly to facilitate unplugging the lamp connector.
|
9. |
Unplug the connector and lift away the headlamp.
|
To fit |
1. |
Position the headlamp drain hose so that it point downward.
|
2. |
Spray with "Kontakt 61" and plug in the connector. Fit the headlamp at an angle towards the mounting. Press the clip onto the front wing.
|
3. |
Fit the screws to secure the headlamp.
|
4. |
Fit the protective cover on the lamp.
|
5. |
Plug in the direction indicator.
|
6. |
Place the direction indicator so that the three guide pins are correctly located. Press on the direction indicator, making sure the clip fastens properly.
|
7. |
Fit the side grille and centre grille by pressing them back in position.
|
8. |
LH:
Fit the top of the battery cover.
|
9. |
Check headlamp alignment and adjust as necessary, see
Headlamp adjustment
.
|