SAAB WIS ONLINE

Master cylinder, RHD

Master cylinder, RHD

To remove


1. V6 TiD: Remove the upper intake manifold.


2. V6 TiD: Remove the upper engine cover.

3. Drain the brake fluid reservoir. Use 88 19 096 Bleeding equipment . Then connect the brake bleeder to the bleed nipple on each front brake caliper and draw out the remaining brake fluid.

If changing the master cylinder: Remove the brake fluid reservoir, see Brake fluid reservoir, RHD .

4. Disconnect the brake pipes and plug them.


5. Remove the two master cylinder retaining nuts and lift out the master cylinder.


To fit


1. Fit the two master cylinder retaining nuts.

Tightening torque: 25 Nm (18 lbf ft)


2. Connect the brake pipes. Make sure the pipes are positioned correctly in their clips.

Tightening torque: 16 Nm (12 lbf ft)

3. If the master cylinder has been changed: Fit the brake fluid reservoir, see To fit .

4. V6 TiD: Fit the upper engine cover.


5. V6 TiD: Fit the upper intake manifold.

6. Bleed the brake system, see Bleeding the brake system .