SAAB WIS ONLINE

Wheel sensor, front left

Wheel sensor, front left

To remove


1. Remove the battery cover.

2. Remove the battery.

3. Remove the maxi fuse holder.


4. Remove the battery tray.

5. Remove the clip and twist out the coolant reservoir.

6. Unplug the connector.


7. Remove the clip from the bracket.

8. Remove the clip from the connector.

9. Raise the car and remove the wheel.

10. Clean the area round the wheel sensor using a soft wire brush.

11. Undo the wheel sensor retaining bolt and remove the wheel sensor.


12. Remove the grommet and withdraw the lead.


13. Detach the lead from the clips and lift out the sensor.


To fit



1. Fit the wheel sensor into the holder.

2. Insert the lead through the rubber grommet.

3. Fit the rubber grommet.


4. Press the lead into the clips.

5. Fit the wheel and lower the car. The wheel must be suspended freely when tightening the wheel bolts. See Wheels .

Tightening torques

aluminium wheel 110 Nm (81 lbf ft)

steel wheel 50 Nm +2x90°, max. 110 Nm (37 lbf ft +2x90°, max. 81 lbf ft)

6. Fit the clip to the connector.


7. Fit the clip in the bracket.

8. Plug in the connector.

9. Fit the coolant reservoir.


10. Fit the battery tray.

11. Fit the maxi fuse holder.

12. Fit the battery.

13. Fit the battery cover.