SAAB WIS ONLINE

Rear bumper, 4D with towbar

Rear bumper, 4D with towbar

To remove



1. Undo the screws in the wheel housing, 2 on each side.

2. Open the boot lid.

3. Remove the luggage compartment sill.


4. Fold away the luggage compartment carpet and remove the seals. The old seals must be discarded and replaced by new ones:


5. Remove the nuts holding the bumper.

6. Remove the protective mouldings using 82 93 474 Removal tool .


7. Remove the bolts from the inside and hold the nuts through the 2 holes behind the protective moulding.

Come cars have press nuts and in such cases it is sufficient to just remove the bolts.

8. Detach the towbar connectors and the bolts holding the towbar to the body.


9. Together with an assistant, pull out the bumper from the clips and lift the bumper out backwards.

10. For cars equipped with Saab Parking Assistance (SPA): Remove the connector.

Important

Be careful to avoid damaging the paintwork.



To fit


1. For cars equipped with Saab Parking Assistance (SPA): Attach the connector.


2. Place the towbar connector in the bumper cavity.

3. Place the bumper in position and press it over the edge of the wheel housing. Make sure that the clips sit correctly.

4. Fit the bumper's nuts and bolts.

5. Fit the screws in the edge of the wheel housing.


6. Fit the bolts and nut plates that secure the towbar to the body.

Attach the towbar connector.


7. Fit new seals and fold down the luggage compartment carpet.

8. Fit the scuff plate.


9. Fit the luggage compartment carpet.

10. Fit the protective mouldings.


11. Close the boot lid and check the bumper fit.