Pedal potentiometer, LHD

/ 9-5 (9600) / 2004 / 2. Engine / Pedal potentiometer, diesel / Adjustment/replacement / Pedal potentiometer, LHD

To remove

1.	Make sure the ignition is turned to LOCK.

2.	Remove the screws to the data link connector.

3.	Remove the lower dashboard panel with air panel on the driver's side, 3 screws and 1 clip.

4.	Unplug the floor lighting connector.

5.	Unplug the accelerator pedal potentiometer connector.

6.	Undo the nuts securing the accelerator pedal.

7.	Remove the pedal and potentiometer.

To fit

1.	Fit the nuts securing the accelerator pedal. Tightening torque 20 Nm (18 lbf ft)

2.	Plug in the pedal potentiometer connector.

3.	Plug in the connector for the floor lighting.

4.	Fit the lower dashboard panel with air duct.

5.	Fit the screws for the data link connector.

---

---

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.