SAAB WIS ONLINE

Accelerator pedal, 4-cyl.

Accelerator pedal, 4-cyl.

To remove


1. Lower the cover (A) for the data link connector.


2. Unscrew the screws (B) in the data link connector.

3. Undo the screws and the clip that secures the lower panel with the air duct (C).

4. Unplug the connector (A) for the floor lighting.


5. Lift away the lower panel.

6. Undo the accelerator cable (B) from the accelerator pedal by moving the bushing backwards and then unhooking the cable and bushing.

7. Remove the pedal (C).


To fit

Note

Spray the connector with Kontakt 61, part no. 30 04 520, before plugging in.

The bushing must not be lubricated.



1. Fit the pedal (C). Tightening torque: 24 Nm (17.7 lbf ft).


2. Fit the accelerator cable (B) to the accelerator pedal.

3. Lift up the lower panel.

4. Plug in the connector (A) for the floor lighting.


5. Fit the lower panel with air duct (C).

6. Fit the screws (B) for the data link connector.

7. Raise the cover (A) for the data link connector.


Check and adjust the cable as necessary.

Tightening torque: 24 Nm (17.7 lbf ft).