Remote control receiver (Japan)
|
|
Remote control receiver (Japan)
|
|
1.
|
Raise the floor console armrest.
|
|
2.
|
Remove the rear part of the floor console by carefully prising up the front edge to release the hook. Lift up the back part of the floor console and tilt it backwards.
|
|
3.
|
Unplug the connector from the back part of the floor console.
|
|
4.
|
Pull loose the receiver unit from the side wall of the floor console and unplug the connector in the unit.
|
|
1.
|
Plug in the connector to the receiver unit. Turn the unit so that the connector is points to the rear of the car.
|
|
2.
|
Fit the receiver unit into the recess in the side wall of the floor console.
|
|
3.
|
Fit a clip to the right side wall of the floor console.
|
|
4.
|
Place the wiring harness to the receiver unit into the clip so that it runs just under the bottom edge of the air duct opening.
|
|
5.
|
Plug in the connector to the rear part of the floor console.
|
|
6.
|
Fit the rear part of the floor console by positioning the lower pins in the holes and carefully pressing down the front to engage the hooks.
|
|
7.
|
Lower the floor console armrest.
|
|
8.
|
Check the operation of the remote control.
|
