SAAB WIS ONLINE

Gear lever

Gear lever

To remove


1. Remove the gear lever housing as described in .


2. Remove the lock plate holder.

3. Remove the spring securing the lock plate.

4. Use a screwdriver to disengage the pawl which is controlled from the ignition switch. Lift up the lock plate together with its plastic bracket.

5. Remove the deflection limiter.

6. Set the gear lever to reverse and undo the screw securing the selector rod to the gear lever.


7. Remove the gear lever and ball socket by carefully pressing in the three tabs on the socket using a screwdriver.


To fit



1. Insert the gear lever and ball socket in the gear lever housing. The O-ring should be between the ball socket and the housing.

2. Insert the screw securing the selector rod to the gear lever.

Tightening torque: 20 Nm (15 lbf ft).

3. Insert the deflection limiter.


4. Insert the lock plate. Check that the lock plate's 2 bearings (rubber bush and dome) in the housing are in place.

5. Snap the ignition switch pawl into the lock plate.

6. Put the lock plate bracket in place. Apply Loctite 242, part no. 74 96 268, to the bolts holding the lock plate bracket.

7. Fit the lock plate spring.

8. Adjust the position of the lock plate with the screw on the lock plate holder so that it is level with the lug in the gear lever housing.


Important

The deflection limiter must not be in contact with the lock plate during adjustment.


9. Fit the complete gear lever housing and selector rod as described in .