SAAB WIS ONLINE

Linkage VIN -43501882

Linkage VIN -43501882

In-car removal



1. Lift up the electrical centre.

2. Engage 4th gear.

3. Remove the plastic plug from the gearbox and insert 87 92 335 Locking pin so that the 4th gear is locked.

4. Undo the linkage attachment at the engine mount.

5. Undo the selector rod attachment clamp.

6. Undo the connection to the gearbox.

7. Remove the linkage and the washer.


In-car assembly



1. Fit the washer and linkage to the gearbox and also to the selector rod, do not tighten the selector rod clamp. Tighten the bolt to the gearbox. Use 74 96 268 Thread locking adhesive .

Tightening torque: 20 Nm (15 lbf ft)

2. Screw the linkage bracket to the engine mounting. Apply Thread locking adhesive, Loctite 270 to the bolts and tighten them.

Tightening torque: 8 Nm (6 lbf ft)

3. Engage 4th gear.


4. Lift up the gear lever boot. Position the gear lever in 4th gear and lock the selector rod with M99-: 87 92 632 Locking pin -M98: 87 92 335 Locking pin


5. Tighten the selector rod attachment clamp.

Tightening torque 22 Nm (16 lbf ft)

6. Remove the locking pin.

7. Fit the plastic plug.

8. Remove the locking pin from the gear lever housing and replace the boot.

9. Fit the electrical centre.

10. Check that all gears can be engaged and that the key can be removed when in reverse.