SAAB WIS ONLINE

Ventilation fan control

Ventilation fan control

To remove


1. Put the air recirculation flap in position OFF.

Ignition in LOCK position.


2. Remove the lower panel from the driver's side, 3 screws.


3. Remove the data link connector, 2 screws, and detach the leads to the floor lighting.

4. LHD : Detach the accelerator cable from the accelerator pedal.


5. LHD : Remove the accelerator pedal, 2 nuts.

6. Remove the glove box. See Glove box .


Remove the trim from the side of the centre console.

7. Loosen the two front connectors above the filter cartridge.

Unplug the contacts from the plate and cut the cable tie.

8. Remove the wiper arms with special tool 85 80 144 Puller, windscreen wiper arm .


9. Remove the rubber seals from the wiper spindles.

10. Remove the rubber moulding along the edge of the bulkhead and loosen the clips on one side. Place the rubber moulding on one side.

11. Loosen the cover over the bulkhead partition space (fastened with clips) by lifting it carefully forwards so that it is released from the windscreen.

Hold the wire to the bonnet release to one side and lift the cover backwards towards the windscreen.

Note

Take care when remove the clips.


12. Loosen the clips holding the front edge of the water shield with a screwdriver. Lift off the water shield.


13. RHD : Remove the wiper assembly and unplug the connector.


14. Pull up the wiring harness including rubber seal and cut the cable tie.

Note

Make a note of the position of the wiring harness.



15. Press down the wiring harness on the other side, including the rubber seal to the control unit.

16. Remove the fan control unit with water protector, 2 bolts.



To fit


1. Fit the ventilation fan control with water protector, 2 bolts.


2. Insert the wiring harness through the fan housing by the air recirculation flap.

3. Fit the rubber seal.

4. Insert the wiring harness to the ventilation fan through the protective cover. Observe the foam seal in the hole.

5. Attach the connector and fit a new cable tie for the ventilation fan.

Check that the wiring harness is not in contact with the fan motor or the air recirculation flap.


6. Insert the wiring harness through the hole in the fan housing into the cabin and fit the rubber seal.

7. Fit the contacts on the plate above the filter and fixate the wiring harness with a cable tie.


8. Plug in the connectors above the filter.


9. Replace the side trim on the centre console.

Fit the glove box. See Glove box .

10. LHD : Fit the accelerator pedal, 2 nuts.


11. LHD : Refit the accelerator cable.

12. Screw on the data link connector to the lower panel and replace the floor lighting.


13. Fit the lower panel, 3 screws.

14. RHD : Fit the wiper assembly and connector, 4 bolts.


15. Put back the water shield (fastened with 3 clips on front edge).


16. Insert the cover over the bulkhead partition space from the rear, against the windscreen. Hold the wire to the bonnet to one side and then place it in its groove.

Note

Take care when remove the clips.



17. Fit the rubber strip on the front edge of the bulkhead, 2 clips.

18. Fit the rubber seals on the wiper spindles.

19. Fit the wiper arms.