Recreating surface structure on bumpers, spoilers and scuff plates
Recreating surface structure on bumpers, spoilers and scuff plates |
Note | ||
Always use a gravity feed spray gun with the recommended nozzle (1.8 - 2.4 mm). |
||
HVLP sprays also provide good results. |
1. |
Sand the damaged area with abrasive paper (grade 400 - 500).
|
2. |
Clean the part with Teroson FL cleaner.
|
3. |
Mask the part so that only the damaged area is visible.
|
4. |
Start by priming the damaged area with two layers of a surface structure treatment mixture.
Mixture: 70% Terotex 3000 (white or black) 20% 2K paint To maintain durability, 2K paint must always be used, even for black or white products. 10% Standard curing agent (suitable for paint), but not MS type. |
5. |
Allow to dry and sand if required.
|
7. |
Place the part in a paint oven at 60°C, so that the structure sets.
|
Useful tips; The mixture can also be used to “raise” small plastic burrs on sanded surfaces. The part can be cured in an oven at 60°C and then rubbed with an abrasive cloth, Scotchbrite or the like.