Front crankshaft seal
Front crankshaft seal |
To remove |
1. |
Raise the car and remove the front right wheel.
|
2. |
Remove the lower engine cover and drive belt cover.
|
3. |
Mark the direction of rotation, take the tension off the belt tensioner and remove the multigroove belt.
|
4. |
Remove the crankshaft pulley using
83 95 360 Support, crankshaft pulley
.
|
5. |
Prise out the seal using a screwdriver without damaging the sealing surfaces.
|
To fit |
1. |
Clean the sealing surfaces.
|
2. |
Lubricate the new sea with non-acidic Vaseline and position it on
83 95 410 Assembly tool, front crankshaft seal
.
|
3. |
Position the seal with the protective collar and assembly tool on the crankshaft. Pull in the seal until it is flush with the timing cover using the crankshaft pulley bolt.
|
4. |
Fit the crankshaft pulley with a new bolt. Use
83 95 360 Support, crankshaft pulley
.
Tightening torque: 150 Nm + 45° (111 lbf ft + 45°) |
5. |
Fit the multigroove belt and check its location on all pulleys.
|
6. |
Fit the drive belt cover and the lower engine cover.
|
7. |
Fit the wheel
.
|
8. |
Lower the car, check the engine oil level and top up as necessary.
|