SAAB WIS ONLINE

P0503

Read the instructions below then start the fault diagnostic procedure.

Symptom: CHECK ENGINE. Cruise control inoperative.

P0503


Vehicle Speed. Signal too High.


Fault symptoms


CHECK ENGINE.

Cruise control inoperative.


On-Board Diagnostics

Type of diagnosis:


- Continuous.


Enable criteria:


- Engine running.

- Injection quantity must be under 40 mm 3 /combustion.


Fault criteria:


- The vehicle speed signal from ESP is 290 km/h.


Dependents:


- None.


System reaction to a fault:


- The following limitations apply: ECM will continue to use a substitute value of 0 km/h and cruise control is switched off.


OK report:


- The vehicle speed signal from ESP is less than 290 km/h.


Fault handling: (See section Fault handling III, other emissions-related components and functions for more information)


- Type III.


Diagnostic help

Fault diagnosis concerns an electrical fault in connecting leads or in the sensor.

Functions in the diagnostic tool related to the fault:


- Read value: Vehicle Speed


The vehicle speed signal goes via BUS on cars equipped with ESP.

See also description of read value under "Read Values" menu for more information.

Checking the wiring

Jiggle the wiring harness at several points and in different directions to detect intermittent breaks and short circuits. Observe the multimeter, diagnostic tool or test lamp during the check.