P1245
Read the instructions below then
start the fault diagnostic procedure.
Symptom: Poor driveability.
Loss of performance.
Turbo position sensor, Low. Performance Problem.
Fault symptom
On-Board Diagnostics
Type of diagnosis:
Enable criteria:
|
-
|
Battery voltage should be 10.2-15.8 V.
|
|
-
|
Engine speed should be over 1700 rpm.
|
|
-
|
Coolant temperature between 59°C - 110°C.
|
|
-
|
Requested position for VNT sensor. Lift more than 2% and that 5 consecutive measurements of the VNT position do not differ by more than 3%.
|
|
-
|
P1636 or P1637 should not be detected.
|
|
-
|
These conditions should be fulfilled for 2 seconds before diagnostics run.
|
Fault criteria:
|
-
|
VNT position is 3.5 mm lower than desired.
|
Dependents:
System reaction to a fault:
OK report:
|
-
|
Fault criteria not fulfilled.
|
Fault handling:
(See section
Fault handling III, other emissions-related components and functions
for more information)
Diagnostic help
Fault diagnosis concerns an electrical fault in connecting leads or in the sensor.
Functions in the diagnostic tool related to the fault:
|
-
|
Read value:
Requested VNT Position,
Actual VNT Position
|
See also description of read value under
"Read Values" menu
for more information.
Checking the wiring
Jiggle the wiring harness at several points and in different directions to detect intermittent breaks and short circuits. Observe the multimeter, diagnostic tool or test lamp during the check.
