Cruise control not working
Read the instructions below then
start the fault diagnostic procedure.
Symptom: Cruise control not working.
|
|
Cruise control not working
|
Fault symptoms
Cruise control not working.
Conditions
The following conditions apply for the current fault symptom:
|
-
|
No DTCs stored in the car with the fault symptom in question.
|
Diagnostic help
The car is driven and cruise control engaged while checking the conditions for cruise control with the diagnostic tool. Start fault diagnosis on the condition that cannot be fulfilled.
The diagnostic tool contains a group of readings entitled ”REASON CC WAS SWITCHED OFF”. The values are from the latest occasion cruise control was working and shows the reason it was disengaged. They are stored as long as the control module is energized and are therefore suitable for locating intermittent faults.
The read values on the diagnostic tool related to the fault:
|
•
|
Clutch or Brake Switch, unit ON/OFF.
|
|
•
|
Brake light, unit ON/OFF.
|
|
•
|
Vehicle Speed (Wire from ABS), unit km/h.
|
|
•
|
Vehicle Speed (Bus from MIU), unit km/h.
|
|
•
|
All values in group ”CONDITIONS FOR CRUISE CONTROL”.
|
|
•
|
All values in group ”REASON CC WAS SWITCHED OFF”.
|
See also description of read value under
"Read Values" menu
for more information.
For more information, see
Cruise control
.
Checking the wiring
Jiggle the wiring harness at several points and in different directions to detect intermittent breaks and short circuits. Observe the multimeter, diagnostic tool or test lamp during the check.
