SAAB WIS ONLINE

Fuel filter/fuel heater, V6

Fuel filter/fuel heater, V6

Warning

Removal of the fuel filter involves partial dismantling of the car's fuel system. The following points must therefore be observed in connection with this work:

• Work only in a well-ventilated area! If approved equipment for the extraction of fuel vapours is available, be sure to use it.

• Wear suitable gloves! Prolonged contact with fuel can cause skin irritation or dermatitis.

• Keep a class BE fire extinguisher near at hand! Be mindful of the danger of sparks caused by short circuits and when connecting and disconnecting leads in electrical circuits.

• No smoking anywhere in the vicinity.

• Wear protective goggles.


Important

Be particulary observant regardning cleanliness when working on the fuel system. Loss of function may occur due to very small particles. Prevent dirt and grime from entering the fuel system by cleaning the connections and plugging pipes and lines during disassembly. Use 82 92 948 Plugs, A/C system assembly. Keep components free from contaminants during storage.


To remove


1. Raise the car.

2. Drain the fuel filter to avoid unnecessary spill, see Draining the fuel filter .


3. Remove the feeder line using the removal tool 83 95 261 Tool, fuel line .

4. Remove the filter holder by pressing it up and out of the bracket on the fuel tank.

5. Detach the preheater connector from the filter holder.

6. Detach the inlet hose from the tank.

7. Unscrew the filter holder cap.

8. Remove the filter.



To fit


1. Insert the filter.


2. Screw on the filter holder cap.

3. Fit the inlet hose to the tank.


4. Fit the preheater connector to the filter holder.

5. Fit the filter holder by hooking it to the bracket on the fuel tank.

6. Fit the feeder line.

7. Lower the car to the floor.

8. Bleed the fuel system, see Bleeding the fuel system .