SAAB WIS ONLINE

Air cleaner casing

Air cleaner casing

To remove


1. Unplug the mass air flow sensor connector.


2. Loosen the hose clips on the connecting hoses.

3. Remove the mass air flow sensor.

4. Raise the car.

5. Remove the right front wheel and wing liner.


6. Loosen the rear section of the bumper shell from the wing

7. Remove the nuts for the rubber mountings from the subframe.


8. Remove the air cleaner. If it is being changed, transfer the hose to the new air cleaner and fit a new filter element.



To fit


1. Coat the air filter guide pin with Vaseline, non-acidic or the equivalent. Fit the air filter housing. Make sure the air filter housing guide pin is correctly positioned in the rubber bushing.


2. Fasten the bumper shell.

3. Fit the wing liner and wheel. See Wheels .


4. Fit the nuts for the rubber mountings to the subframe.


5. Lower the car to the floor.

6. Fit the mass air flow sensor and tighten the hose clips on the connecting hoses.

Tightening torque, mass air flow sensor: 3.5 Nm (2.5 lbf ft)


7. Plug in the mass air flow sensor connector.