Accelerator pedal, 4-cyl.
Accelerator pedal, 4-cyl. |
To remove |
1. |
Lower the cover (A) for the data link connector.
|
2. |
Unscrew the screws (B) in the data link connector.
|
3. |
Undo the screws and the clip that secures the lower panel with the air duct (C).
|
4. |
Unplug the connector (A) for the floor lighting.
|
5. |
Lift away the lower panel.
|
6. |
Undo the accelerator cable (B) from the accelerator pedal by moving the bushing backwards and then unhooking the cable and bushing.
|
7. |
Remove the pedal (C).
|
To fit |
Note | ||
Spray the connector with Kontakt 61, part no. 30 04 520, before plugging in. |
||
The bushing must not be lubricated. |
1. |
Fit the pedal (C). Tightening torque: 24 Nm (17.7 lbf ft).
|
2. |
Fit the accelerator cable (B) to the accelerator pedal.
|
3. |
Lift up the lower panel.
|
4. |
Plug in the connector (A) for the floor lighting.
|
5. |
Fit the lower panel with air duct (C).
|
6. |
Fit the screws (B) for the data link connector.
|
7. |
Raise the cover (A) for the data link connector.
|
Check and adjust the cable as necessary.
Tightening torque: 24 Nm (17.7 lbf ft).