SAAB WIS ONLINE

EVAP close valve

EVAP close valve

To remove


1. Raise the car.


2. Cut the cable tie.

3. Unplug and detach the connector to the purge device.

4. Detach the purge device from the filler pipe bracket with a screwdriver.

5. Clean the purge device.

6. Remove the top cover over the shut-off valve.

7. Unplug the connector from the shut-off valve and remove the washer.


8. Move the cover along the hose so that the hose clip is accessible.

9. Remove the valve by undoing its hose connection.


To fit



1. Connect the valve to the hose.

2. Connect the hose.

3. Refit the washer.

4. Fit the cover over the valve, making sure the cables end up in the washer opening.

Important

Take care with the foam rubber filter so that it is not damaged or incorrectly fitted.


5. Spray with Kontakt 61 and plug in the connector.

6. Fit the front cover.


7. Fit the purge device to the filler pipe.

8. Spray with Kontakt 61 and plug in the connector to the purge device.

9. Secure the cables with a cable tie.

10. Lower the car to the floor.