Turbo boost gauge
| Turbo boost gauge |
The gauge is driven by a stepper motor which is controlled by the main instrument control module.
The value shown by the boost gauge needle is based on the following: Trionic calculates the mg air mass/consumption and converts this information to a value between 0 and 255. Trionic sends this as a bus message "boost gauge". This value corresponds quite well to the engine torque. The main instrument unit uses this value for the boost gauge needle which shows the driver the load on the engine.
Diagnostics
The function has its own diagnostics in the sending system.
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
