Gear selector casing
Gear selector casing |
1. |
Put the gear selector in position N or D.
|
2. |
Remove the screw holding the front part of the gear selector casing.
|
3. |
Remove the front part.
|
4. |
Press up the SPORT button from below.
|
5. |
Unsolder the SPORT button. Lay a guard underneath so the solder does not drip onto the centre console.
|
6. |
Dismantle the lock and pull up the release button together with the rear part of the gear selector casing. Leave the electric wires in the casing.
|
To fit |
1. |
Put in place the electric wiring in the lower part of the casing and fit them to the lever. Lubricate the whole U section where the release button runs with grease part no. 82 93 243. Distribute the grease evenly on all three sides so the release button runs easily.
|
2. |
Fit the release button and press it down together with the selector casing until the screw casing is opposite the hole in the gear selector.
|
3. |
Thread the electric wires through the hole and solder on the SPORT button. Lay a guard underneath so that solder does not drop on the centre console.
|
4. |
Press in place the SPORT button.
|
5. |
Lay the electric wires in a loop so they do not get pinched and press them into the groove behind the release button.
|
6. |
Fit the lock to the release button.
|
7. |
Fit the front part of the gear selector casing.
|
8. |
Screw together the gear selector.
|