Windscreen wiper assembly
|
Windscreen wiper assembly
|
2.
|
Remove the protective cover retaining screws and the rubber seals from the wiper spindles.
|
3.
|
Loosen the rubber moulding along the edge of the bulkhead and let it rest on the wings.
|
4.
|
Lift off the cover on the bulkhead partition space.
|
5.
|
Lift off the cover over the centre spindle and the climate housing.
|
6.
|
Unplug the wiper motor connectors.
|
7.
|
Remove the 4 wiper assembly retaining screws.
|
8.
|
Lift out the whole windscreen wiper assembly.
|
1.
|
Fit the windscreen wiper assembly.
Tightening torque: 8 Nm (6 lbf ft).
|
2.
|
Plug in the connectors.
|
3.
|
Fit the cover over the centre spindle and climate housing.
|
4.
|
Fit the cover on the bulkhead partition space.
Important
|
Make sure that the 5 catches are under the windscreen
|
|
|
5.
|
Fit the rubber moulding on to the bulkhead and the spindles' rubber seals.
|
6.
|
Fit the wiper arms at the correct angle.
The distance between the wiper blade mounting on the wiper arm and the cover should be:
Driver's side = 39 mm
Passenger side = 57 mm.
|
Extra strokes (yes/no).